Liberty Category 6A Non-Continuity Shield (NCS) U/UTP Riser
Liberty's newest Data cable is a special construction where the shield is fully encapsulated with non-conductive Mylar. There is no Drain wire. This special format has been around for a while, its original function was to drive cable diameters lower for UTP Cat6A 10G Networking. It has an added benefit for use in both Data and HDBaseT(R) runs by removing ground loop issues. Have you noticed HDBaseT runs where the Transmitters seem to go bad regularly? That is a symptom of a ground loop. Replacing the shielded cable with this "NCS" version lifts the ground loop without introducing a junction or patch out solution. Running the NCS version versus a shielded cable also helps as you can use cheaper unshielded (UTP) format jacks and plugs with this cable. Available in both Plenum rated and Riser rated formats, cure those grounding issues with this newest Liberty cable.
- 23 AWG Solid Bare Copper Conductors
- Polyolefin Insulation
- Varying lay twisted pairs cabled on a common axis
- Fully encapsulated poly/foil/poly binder
- Riser rated Polyvinyl Chloride Jacket
- Third Party (UL, ETL) certified to Category 6A performance
- Fully Certified to 500 MHz
- NEC Rated CMR, CEC Rated CMG FT4, RoHS Compliant
- 1000 Foot Spools Standard
- LAN/HDBaseT where grounding loops are prevalent
- Non-Plenum LAN 10/100/1000/10GBaseT Networking
- Balun Infrastructure, Voice, Voice over IP cabling
- Video, Audio, InfraRed, IP Control, Modulated RF Video
- PoE, HDBaseT, Analog and Digital Multimedia
PVC-coated Products; PVC-coated Wires and Cables
WARNING: This product can expose you to chemicals including DINP and/or DEHP, which are known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov or our information page: California Proposition 65.
FTPU60A
OCCUFP6A
1110808005634
1A68TP0A0-BK
1A68TP0A0-BL
1A68TP0A0-GN
1A68TP0A0-GY
1A68TP0A0-OR
1A68TP0A0-RD
1A68TP0A0-WH
1A68TP0A0-YL
